Welcome, Guest. Please Login or Register
Dynon Avionics, Inc.
 
Welcome to the Dynon Avionics forum!

Note: This forum will be less actively monitored while we are at AirVenture Oshoksh 2017.
For technical support needs, please contact us at 425-402-0433 or support at dynonavionics dot com.
  HomeHelpSearchLoginRegister  
 
 
Page Index Toggle Pages: 1
Send Topic Print
Backup Network Error (Read 658 times)
Jul 6th, 2017 at 9:03am

Dan Dorschel   Offline
New Member
I love flying!

Posts: 7
*
 
Attached is a picture of my Network Status page. I am getting a Backup Network Error under the warnings menu. This is a Van's RV12 with Skyview.
I am not sure how to tell where to begin trouble shooting the issue. Is the Serial # the designation of where the problem is?
« Last Edit: Jul 6th, 2017 at 9:04am by Dan Dorschel »  

Network_Staus.jpg (1064 KB | 10 )
Network_Staus.jpg
IP Logged
 
Reply #1 - Jul 6th, 2017 at 4:36pm

Dynon Avionics   Offline
Dynon Official
Dynon Technical Support

Posts: 12663
*****
 
Basically, that means that those wires (that go to pins 4/8 on the D9 connector) are likely not connected or run to your AP servos.

Is this an upgrade from a D100-based system by any chance? There are two pairs of SkyView Network wires that need to be connected. The D10/D100 series only had one pair. So when upgrading, if the system wasn't "pre-wired" with the additional two wires, you'd need to add them. I don't recall the details of Vans' previous wiring, but even back then we knew that we'd one day use both sets, so I'm surprised to see them not connected.
 

Please do not use Private Messaging on form to contact. For private support:
Email: support at dynonavionics dot com
Phone: 425-402-0433 (7am-5pm Pacific weekdays)
IP Logged
 
Reply #2 - Jul 7th, 2017 at 3:38am

Dan Dorschel   Offline
New Member
I love flying!

Posts: 7
*
 
Thanks,
It is one of the conversion harnesses. Is it possible that the wires provided with that harness could be reversed causing this issue?
 
IP Logged
 
Reply #3 - Jul 7th, 2017 at 5:26pm

Dynon Avionics   Offline
Dynon Official
Dynon Technical Support

Posts: 12663
*****
 
I can't speak to its exact construction off the top of my head, but I'd probably start by tracing all of the wires to see if there's a discontinuity there.
 

Please do not use Private Messaging on form to contact. For private support:
Email: support at dynonavionics dot com
Phone: 425-402-0433 (7am-5pm Pacific weekdays)
IP Logged
 
Reply #4 - Jul 7th, 2017 at 5:55pm

Dynon Avionics   Offline
Dynon Official
Dynon Technical Support

Posts: 12663
*****
 
Actually, it looks like Van's has a service bulletin for their wiring harness / box interface. Check out

https://www.vansaircraft.com/public/service-rv12.htm

...specifically Aug. 31, 2012 - Wiring change for Skyview
 

Please do not use Private Messaging on form to contact. For private support:
Email: support at dynonavionics dot com
Phone: 425-402-0433 (7am-5pm Pacific weekdays)
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Print