Welcome, Guest. Please Login or Register
 Dynon Avionics, Inc.
 
Welcome to the Dynon Avionics forum!

Note: This forum will be less actively monitored while we are at AirVenture Oshoksh 2017.
For technical support needs, please contact us at 425-402-0433 or support at dynonavionics dot com.
 
  HomeHelpSearchLoginRegister  
 
 
  Dynon Avionics Forum › EFIS discussion › Autopilot Installation Support › connection between D180 and AVMAP EKPV no success
(Moderator Groups: Dynon Employee, Dynon Official)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1
Send Topic Print
connection between D180 and AVMAP EKPV no success (Read 60 times)
Jul 13th, 2017 at 11:47pm

ALPI   Offline
New Member
I love flying!

Posts: 1
 *
 
Hi, i have installed D180, AP74 , 2 servos and a gps EKPV.Track and NAV do not work. I have cabling from dynon harness DB25 (NOT PC DB25), TX on RX(gps com A) and RX to TX. GND TO GND.
Set on GPS : NMEA, full messages, 4800 (i tried also AUTO), com A
on D180 : EMS and EFIS serial : 4800, NMEA
I dont know how i can see on D180 if receive informations, same on GPS ..not able to know if informations transmitted..
So if any idea? thx
 
Back to top 
IP Logged
 
Reply #1 - Jul 14th, 2017 at 4:18pm

Dynon Avionics   Offline
Dynon Official
Dynon Technical Support

Posts: 12663
 *****
 
Hi Alpi - That should do it. What do you see on the top half HSI page on the D180? Is there any text in magenta/pink? Also, once you're in the HSI page, bring up the HSI menu and press the NAVSRC button. Does that cycle the GPS info on and off?
 
Please do not use Private Messaging on form to contact. For private support:
Email: support at dynonavionics dot com
Phone: 425-402-0433 (7am-5pm Pacific weekdays)
Back to top 
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Print
‹ Previous Topic | Next Topic ›
  « Home ‹ Board Top of this page

Dynon Avionics Forum » Powered by YaBB 2.5 AE!
YaBB Forum Software © 2000-2010. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge