Welcome, Guest. Please Login or Register
Dynon Avionics, Inc.
 
Welcome to the Dynon Avionics forum!
  HomeHelpSearchLoginRegister  
 
 
Page Index Toggle Pages: 1
Send Topic Print
What is the purpose D120 Ground PINS 5, 16, and 17 (Read 129 times)
Nov 14th, 2017 at 8:44am

John McGlynn   Offline
New Member
I love flying!

Posts: 1
*
 
Hi, I am wiring my D100 and D120 into the panel of my RANS S-19 Venterra with a JABIRU 3300.  I am not sure what to do, if anything, with PINS 5, 16, and 17 on the D-120 37 pin connector. They are labeled as GROUND and the reference paragraph is 2.2.  Unfortunately there is no reference to ground pins in that paragraph.  Any ideas about their purpose?
Regards
John
 
IP Logged
 
Reply #1 - Nov 14th, 2017 at 3:47pm

jakej   Offline
Expert
Australia

Gender: male
Posts: 1452
*****
 
They are standard to the supplied loom & should be used for various engine sensors, eg Kavlico or some VDO types, in the first instance.  Otherwise they are just spare grounds, no need to connect them if not actually used as above, same applies to some other coloured wires in the loom.  I usually remove any excess/unused wires as they can act as an 'antenna' to introduce "noise" into the system.
 
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Print