Welcome, Guest. Please Login or Register
Dynon Avionics, Inc.
 
Welcome to the Dynon Avionics forum!


  HomeHelpSearchLoginRegister  
 
 
Page Index Toggle Pages: 1
Send Topic Print
AP Servos & ADAHARS not detected (Read 1173 times)
Feb 14th, 2018 at 3:17pm

JayRV12   Offline
New Member
I love flying!

Posts: 9
*
 
Dual D1000 HDX - Neither the ap servos nor the adahars are being detected.  and below the first SV Display I am getting a 'Skyview Network Connection Fault - Data 2 Pair (Pins 4 & 8)'.  Are these items related?  Anyone have an idea to fix this?
 
IP Logged
 
Reply #1 - Feb 14th, 2018 at 5:45pm

Dynon Avionics   Offline
Dynon Official
Dynon Technical Support

Posts: 13013
*****
 
Probably. First, disconnect both cables from the display, and do a network configuration. Are you still getting that error? If so, it may be the display. If not, it's probably the SkyView Network cable, or possibly one of the devices. That error is telling you that something is up with the wires on pins 4/8. Assuming you pass the above test, if you have two network cables going out from the display, you'll want to connect / detect with them connected individually to start narrowing down where the issue is.
 

Please do not use Private Messaging on form to contact. For private support:
Email: support at dynonavionics dot com
Phone: 425-402-0433 (7am-5pm Pacific weekdays)
IP Logged
 
Reply #2 - Feb 22nd, 2018 at 4:45pm

JayRV12   Offline
New Member
I love flying!

Posts: 9
*
 
I had the adahrs wired incorrectly.  That is now up.  I am still not detecting the ap servos
 
IP Logged
 
Reply #3 - Feb 22nd, 2018 at 4:52pm

Dynon Avionics   Offline
Dynon Official
Dynon Technical Support

Posts: 13013
*****
 
What are you seeing on your network status page now?
 

Please do not use Private Messaging on form to contact. For private support:
Email: support at dynonavionics dot com
Phone: 425-402-0433 (7am-5pm Pacific weekdays)
IP Logged
 
Reply #4 - Mar 12th, 2018 at 12:50pm

JayRV12   Offline
New Member
I love flying!

Posts: 9
*
 
I see the AP panel and the knob panel.  No memtion of the servos.
 
IP Logged
 
Reply #5 - Mar 13th, 2018 at 5:38pm

Dynon Avionics   Offline
Dynon Official
Dynon Technical Support

Posts: 13013
*****
 
Have they EVER been detected? If not, are they definitely receiving ship's power? Note that the servos don't wire quite the same way as other SkyView Network devices. Instead of being powered by the SkyView Network cable themselves, they should have dedicated higher current 12V power/ground going to their power wires.
 

Please do not use Private Messaging on form to contact. For private support:
Email: support at dynonavionics dot com
Phone: 425-402-0433 (7am-5pm Pacific weekdays)
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Print