Welcome, Guest. Please Login or Register
Dynon Avionics, Inc.
 


Dynon will be closed 12/24-12/27, and 1/1. This forum will be minimally staffed during the last week of Dec and through the New Year

Have a great Chrismas and New Year!

  HomeHelpSearchLoginRegister  
 
 
Page Index Toggle Pages: 1
Send Topic Print
"Tach Low" + "EMS Fail" (Read 507 times)
Feb 15th, 2018 at 9:29pm

wmince   Offline
Full Member
Clearwater, FL

Gender: male
Posts: 228
***
 
Operating  ROTAX 912 ULS.
Intermittantly, during ground engine operation and in flight, red EMS panel light flickers just briefly, followed by two messages on both Skyviews that display "Tach Low" and "EMS Fail." The messages extinguuish after a few seconds, only to repeat the sequence a few minutes later.
Anomaly is not present until engine is started and running.

Note:  EMS module was replaced and symptoms still remain.
Tomorrow, I will send another diagnostic file to Dynon.

Anybody else experience this phenomena or have any ideas? Sad
« Last Edit: Feb 16th, 2018 at 6:09pm by wmince »  
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Print