Welcome, Guest. Please Login or Register
Dynon Avionics, Inc.
 
Welcome to the Dynon Avionics forum!


  HomeHelpSearchLoginRegister  
 
 
Page Index Toggle Pages: 1
Send Topic Print
Van's Tach Transducer - EMS PIN Wiring (Read 412 times)
Feb 27th, 2018 at 6:33am

CaptainJS   Offline
New Member
I love flying!

Posts: 6
*
 
I would like to confirm which EMS PIN to use with the Van's Tach transducer.

I am using the Van's Tachometer transducer (IE VTACHGEN 2) as the source input signal for both my Skyview and my backup Van's Tach Gage. The Vans transducer has 3 wires, one for ground, one for 12V input power, and the signal wire that goes to the Van's Tach gage.

After reading the Dynon installation manual, I am assuming that I can use the Van's tach transducer signal to provide RPMs to the Skyview system and that the signal from the Van'stach transducer should be connected to PIN 32 (RPM Left Standard) on the EMS D37 connector?

Any input folks have on this topic would be appreciated.

Thanks,
Jerry
« Last Edit: Feb 27th, 2018 at 6:33am by CaptainJS »  
IP Logged
 
Reply #1 - Feb 27th, 2018 at 3:58pm

Dynon Avionics   Offline
Dynon Official
Dynon Technical Support

Posts: 13013
*****
 
Yep, that should do the trick. You want to use the standard rpm inputs, not the low voltage inputs.
 

Please do not use Private Messaging on form to contact. For private support:
Email: support at dynonavionics dot com
Phone: 425-402-0433 (7am-5pm Pacific weekdays)
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Print