Welcome, Guest. Please Login or Register
Dynon Avionics, Inc.
 
Welcome to the Dynon Avionics forum!


  HomeHelpSearchLoginRegister  
 
 
Page Index Toggle Pages: 1
Send Topic Print
SV-32 AP Servos not detected (Read 283 times)
Feb 27th, 2018 at 12:12pm

JayRV12   Offline
New Member
I love flying!

Posts: 9
*
 
I have checked for the correct wiring a whole bunch of times and they seem to be correct, but Skyview is not finding them. Do you have a way that I can bench test the servos to see if it is in the servos themselves?
« Last Edit: Feb 27th, 2018 at 12:12pm by JayRV12 »  
IP Logged
 
Reply #1 - Feb 27th, 2018 at 1:44pm

RayInGA   Online
Senior Member
I love aviation!
Richmond Hill, GA

Gender: male
Posts: 463
****
 
When I had an issue with my roll servo, I made a short cable to allow connection directly to the network, ground and power, which proved the servo was not working. Dynon repaired it under warranty (before I was flying).

With both servos having the same problem, it is unlikely that they both failed but is possible.

Have you confirmed 12 volts on the existing connection to each servo?
 

Ray Eaker
RV-7A flying since 27 Jan 2017
Dual Skyview 1000T with all available Dynon VFR goodies
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Print