Welcome, Guest. Please Login or Register
Dynon Avionics, Inc.
 
Welcome to the Dynon Avionics forum!


  HomeHelpSearchLoginRegister  
 
 
Page Index Toggle Pages: 1
Send Topic Print
V. 15.3 question (Read 637 times)
Mar 23rd, 2018 at 2:59pm

Jrskygod   Offline
Junior Member
I love flying!

Posts: 51
**
 
In the new section of V. 15.3 It indicates that you can tie the HSI source to the flight plan source. I have looked everywhere in the install and operator manual and can't find how this is done. Anyone have a clue?

This would be nice to have to eliminate any ambiguity as to who is doing what. Cheesy
 
IP Logged
 
Reply #1 - Mar 23rd, 2018 at 4:35pm

Dynon Avionics   Offline
Dynon Official
Dynon Technical Support

Posts: 12963
*****
 
We missed the documentation update for that one. It's under SYSTEM SETUP > ARINC 429, then all the way at the bottom.
 

Please do not use Private Messaging on form to contact. For private support:
Email: support at dynonavionics dot com
Phone: 425-402-0433 (7am-5pm Pacific weekdays)
IP Logged
 
Reply #2 - Mar 24th, 2018 at 7:49am

Jrskygod   Offline
Junior Member
I love flying!

Posts: 51
**
 
Thanks
 
IP Logged
 
Reply #3 - Mar 25th, 2018 at 11:53am

bob m   Offline
Junior Member
arroyo grande, CA

Gender: male
Posts: 63
**
 
Seems like forever ago when I started out with version 1.0.  It has always been somewhat of an issue with me trying to figure out where to find stuff in the manuals.  Sometimes it isn't so obvious whether or not it is in the install manual or pilot manual.  Even knowing which manual, it is sometimes difficult to find unless the section is clear. 
In this case, you didn't mention which manual and you failed to give a section number and I can't find a section called system setup in either manual--not very helpful to my lame brain on a bad day!
 
IP Logged
 
Reply #4 - Mar 25th, 2018 at 3:14pm

Alexe   Online
Frequent Poster
I love flying!

Posts: 20
**
 
Bob M, Dynon was referring to the setup menu on your Skyview, not the documentation.
 
IP Logged
 
Reply #5 - Mar 25th, 2018 at 4:30pm

bob m   Offline
Junior Member
arroyo grande, CA

Gender: male
Posts: 63
**
 
Thanks Alexe, I'll look there.
 
IP Logged
 
Reply #6 - Mar 25th, 2018 at 5:13pm

Jrskygod   Offline
Junior Member
I love flying!

Posts: 51
**
 
I set mine up today. Works fine. I cannot understand why this is under the ARINC area and not the PFD or Flight plan area. Really makes no sense to me  - but hey I'm used to the Garmin mindset so don't expect much. Grin Grin
 
IP Logged
 
Reply #7 - Mar 26th, 2018 at 2:14am

Richard Fazio   Offline
Senior Member

Gender: male
Posts: 258
****
 
I agree, but tried it out and it works perfectly. I flew with it and it works perfectly. SO much easier to switch sources now.
 

Richard Fazio
RV-6, Skyview 10"
AP, ADS-B, Xponder
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Print