Welcome, Guest. Please Login or Register
 Dynon Avionics, Inc.
 
Welcome to the Dynon Avionics forum!
 
  HomeHelpSearchLoginRegister  
 
 
  Dynon Avionics Forum › EFIS discussion › EFIS Installation › D-100 Altitude Output to K-76A Transponder
(Moderator Groups: Dynon Employee, Dynon Official)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1
Send Topic Print
D-100 Altitude Output to K-76A Transponder (Read 137 times)
Apr 5th, 2018 at 1:12am

DuaneFamly   Offline
New Member

Posts: 1
 *
 
Experimental. Just did first flight. Tower says their radar has no Altitude information from me. They read the transponder and Ident but they receive no altitude information. Verified wiring from D-100 to Blind Encoder then to transponder, power to encoder is good, so how can I verify that the D-100 is sending altitude info on the serial TX line?
 
Back to top 
IP Logged
 
Reply #1 - Apr 5th, 2018 at 5:10pm

Dynon Avionics   Offline
Dynon Official
Dynon Technical Support

Posts: 12963
 *****
 
The serial ports virtually never break. It's most often be power to the encoder if there is no data, or one or more output wires that are not properly connected if ATC is seeing erroneous altitude.

Configuration-wise, did you check the altitude encoder format output setting on the EFIS? SETUP > ALTENC >  FORMAT should be set to format 1.
 
Please do not use Private Messaging on form to contact. For private support:
Email: support at dynonavionics dot com
Phone: 425-402-0433 (7am-5pm Pacific weekdays)
Back to top 
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Print
‹ Previous Topic | Next Topic ›
  « Home ‹ Board Top of this page

Dynon Avionics Forum » Powered by YaBB 2.5 AE!
YaBB Forum Software © 2000-2010. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge