Welcome, Guest. Please Login or Register
Dynon Avionics, Inc.
 
Welcome to the Dynon Avionics forum!


  HomeHelpSearchLoginRegister  
 
 
Page Index Toggle Pages: 1
Send Topic Print
SkyView: in Panning Mode + turning track knob (Read 390 times)
May 19th, 2018 at 2:58pm

skyview_user   Offline
Frequent Poster
I love TopMeteo

Posts: 35
**
 
why can I not see the track line?
 
IP Logged
 
Reply #1 - May 21st, 2018 at 6:28am

RayInGA   Offline
Expert
I love aviation!
Richmond Hill, GA

Gender: male
Posts: 512
*****
 
I think you mean "heading line." I too have noticed that it does not show when panning on the screen. Probably a reason or limitation for not showing it. You should still see the heading bug, though.
 

Ray Eaker
RV-7A flying since 27 Jan 2017
Dual Skyview 1000T with all available Dynon VFR goodies
IP Logged
 
Reply #2 - May 21st, 2018 at 9:33am

wmince   Offline
Full Member
Clearwater, FL

Gender: male
Posts: 224
***
 
RayInGA wrote on May 21st, 2018 at 6:28am:
I think you mean "heading line."

Or . . . " track line." Smiley
« Last Edit: May 21st, 2018 at 9:33am by wmince »  
IP Logged
 
Reply #3 - May 21st, 2018 at 12:33pm

RayInGA   Offline
Expert
I love aviation!
Richmond Hill, GA

Gender: male
Posts: 512
*****
 
wmince wrote on May 21st, 2018 at 9:33am:
RayInGA wrote on May 21st, 2018 at 6:28am:
I think you mean "heading line."

Or . . . " track line." Smiley


Well, my SV 1000T system has a heading line, controlled by a heading knob. The autopilot can be set to follow said line in heading mode or in track mode.

Otherwise, I have no idea what the OP is talking about. The post is a bit terse.
 

Ray Eaker
RV-7A flying since 27 Jan 2017
Dual Skyview 1000T with all available Dynon VFR goodies
IP Logged
 
Reply #4 - May 23rd, 2018 at 4:50am

skyview_user   Offline
Frequent Poster
I love TopMeteo

Posts: 35
**
 
Sorry. What I mean is the following behaviour. If you are NOT in panning mode and you turn the heading knob then a cyan line shows up and gives you the new course/heading/track. If the AP is engaged and in TRK mode that's of couse the new track. If you then want to fine tune the new track for a far destination you normally go into panning mode and zoom in the remote location. But when you now turn the haeding/track knob nothing happens. No cyan line is shown.
 
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Print