Welcome, Guest. Please Login or Register
Dynon Avionics, Inc.
 
Welcome to the Dynon Avionics forum!


  HomeHelpSearchLoginRegister  
 
 
Page Index Toggle Pages: 1
Send Topic Print
D10A stays in a reboot cycle (Read 237 times)
May 26th, 2018 at 4:12pm

blueflyer   Offline
Full Member

Posts: 114
***
 
My Dynon D10A will not get past the blue start up screen, then the screen goes black for a second, then the blue startup screen comes on again. The white "d" for dynon does appear on the blue screen. It stays in this cycle until I pull the breaker. What should I do, send it in for repair?
« Last Edit: May 26th, 2018 at 4:13pm by blueflyer »  
IP Logged
 
Reply #1 - May 27th, 2018 at 4:48pm

jakej   Offline
Expert
Australia

Gender: male
Posts: 1566
*****
 
That may be a voltage issue.  Is it installed & what is the system volts ?
Did you also check it out by removing the backup battery, if fitted ?
 
IP Logged
 
Reply #2 - May 30th, 2018 at 4:49pm

Dynon Avionics   Offline
Dynon Official
Dynon Technical Support

Posts: 12984
*****
 
If Jake's excellent troubleshooting tips don't help, we'll need to see it here. Give our support team a call at 425-402-0433 or email at support at dynonavionics dot com if that's the case.
« Last Edit: May 30th, 2018 at 4:50pm by Dynon Avionics »  

Please do not use Private Messaging on form to contact. For private support:
Email: support at dynonavionics dot com
Phone: 425-402-0433 (7am-5pm Pacific weekdays)
IP Logged
 
Reply #3 - May 30th, 2018 at 4:51pm

blueflyer   Offline
Full Member

Posts: 114
***
 
I sent it in for repair.  Thanks for the response.
 
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Print