I have an SV-D1000 and an SV-D700. Dual ADAHRS, single SV-XPNDR-261.

Last year I sent my D1000 in for the [url]http://www.dynonavionics.com/bulletins/support_bulletin_030413.php display circuit board service bulletin[/url]. It's been working fine since then, but today it crashed 4 times in flight, displaying a strange screen (see attached) for about a minute, followed by a black screen and then a reboot. During the time it was showing that screen, it didn't respond to holding down the left button which normally turns it off. The D700 kept working OK except it showed transponder failure, and indeed ATC reported my transponder was not responding. As soon as the D1000 screen went black, the transponder recovered.

It was a hot day, but I checked the D1000 internal temperature while it was working and it showed 67 C which doesn't seem too bad.

Any thoughts? I will be filing a request with Dynon support but I have a long trip planned tomorrow and would appreciate any temporary workarounds people might have.

Thanks!

67 C is quite hot, IMO. That's > 150 F and well beyond what most electronics will tolerate.

Dynon replaced my display for free! Thanks very much indeed, way to build brand loyalty