Welcome, Guest. Please Login or Register
Dynon Avionics, Inc.
 
Welcome to the Dynon Avionics forum!


  HomeHelpSearchLoginRegister  
 
 
Page Index Toggle Pages: 1
Send Topic Print
D10a and Becker BXP6401 set up (Read 61 times)
Aug 11th, 2018 at 3:52pm

John MN   Offline
New Member
I love flying!

Posts: 7
*
 
Hi Guys, What is the set up for a D10a and Becker BXP6401 transponder to enable altitude encoding?  I've tried just about all the variations on both boxes. The transponder check failed.  I get a Becker Error Latch of DATA LINK and of course FAILURE showing up sooner or later.  Thanks, John in MN
 
IP Logged
 
Reply #1 - Aug 13th, 2018 at 7:35am

John MN   Offline
New Member
I love flying!

Posts: 7
*
 
The link below is for the Becker transponder if anyone would like to take a stab at it. Much appreciated.  THX, John

file:///C:/Users/System%20User/Downloads/BXP6401_I&O_issue05%20June%202018.pdf
 
IP Logged
 
Reply #2 - Aug 13th, 2018 at 5:24pm

John MN   Offline
New Member
I love flying!

Posts: 7
*
 
It turns out that two wires on the Becker harness I purchased were in each others pin. The other problem was that there was a ground on one of the db connectors that, due to my panel setup, should not have been there. The BeckerUSA tech guy was a big help in helping figure this out by offering suggestions and pointing me in the correct direction.
 
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Print