Welcome, Guest. Please Login or Register
Dynon Avionics, Inc.
 
Welcome to the Dynon Avionics forum!


  HomeHelpSearchLoginRegister  
 
 
Page Index Toggle Pages: 1
Send Topic Print
Added a Heated Pitot & Connection to EMS (Read 193 times)
Sep 11th, 2018 at 8:22am

Richard Fazio   Offline
Senior Member

Gender: male
Posts: 265
****
 
I added a heated pitot to my RV-6. I also ran the indicator wire to my EMS pin 10 as contact. I went in and added the sensor as a contact and put the contact indicator on the engine page. I can't seem to get it to work. I went in to the EMS setup page and I can see the contact is working. When I put the pitot on I see 5 volts on that pin and when I shut it off it goes to zero. But no indication on my contact indicator on the 100% page? What am I doing wrong?
 

Richard Fazio
RV-6, Skyview 10"
AP, ADS-B, Xponder
IP Logged
 
Reply #1 - Sep 11th, 2018 at 8:32am

RayInGA   Offline
Expert
I love aviation!
Richmond Hill, GA

Gender: male
Posts: 532
*****
 
Richard,

I suggest running through the setup again that begins on page 15-1 of the install manual, rev AD (though the the revision at the bottom of each pages says AC).


 

Ray Eaker
RV-7A flying since 27 Jan 2017
Dual Skyview 1000T with all available Dynon VFR goodies
IP Logged
 
Reply #2 - Sep 12th, 2018 at 3:05am

Richard Fazio   Offline
Senior Member

Gender: male
Posts: 265
****
 
Ray,

Thanks for the response. I did use the install manual for the setup. So I went out to the airport and went in and checked it again, line by line. I had it wrong. It now works, thanks.
 

Richard Fazio
RV-6, Skyview 10"
AP, ADS-B, Xponder
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Print