Welcome, Guest. Please Login or Register
Dynon Avionics, Inc.
 
Welcome to the Dynon Avionics forum!


  HomeHelpSearchLoginRegister  
 
 
Page Index Toggle Pages: 1
Send Topic Print
Running MOGAS and AVGAS Calibration (Read 143 times)
Oct 10th, 2018 at 8:57pm

HomeBuilt101   Offline
Full Member
I love flying!

Posts: 247
***
 
I calibrated my fuel tanks using AVGAS 100 LL however I think I will now be mostly burning MOGAS.

I know the readings will be off when uploading "other" fuel so I was wondering what would be the best technique...Calibrate for MOGAS...or...Calibrate for AVGAS?

I anticipate that I will be using MOGAS more however it might be best to calibrate for the fuel that will read lower on the gauges so when there is 100 percent of the "other" fuel or a mix of both in the tanks.

Any suggestions would be greatly appreciated!!!

THANKS
 
IP Logged
 
Reply #1 - Oct 11th, 2018 at 8:10am

RayInGA   Offline
Expert
I love aviation!
Richmond Hill, GA

Gender: male
Posts: 512
*****
 
If you have float sensors, you are done.
 

Ray Eaker
RV-7A flying since 27 Jan 2017
Dual Skyview 1000T with all available Dynon VFR goodies
IP Logged
 
Reply #2 - Oct 11th, 2018 at 8:55am

airguy   Offline
Senior Member
SkyView Flight Tester
Gods Country - west Texas

Gender: male
Posts: 365
****
 
If you have float sensors you're golden, as mentioned above. If you have capacitance senders, you're going to have difficulties - see my thread here on the Vans forum about that.

http://www.vansairforce.com/community/showthread.php?t=148040
 
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Print