Welcome, Guest. Please Login or Register
Dynon Avionics, Inc.
 
Welcome to the Dynon Avionics forum!


  HomeHelpSearchLoginRegister  
 
 
Page Index Toggle Pages: 1
Send Topic Print
EMS-D10 and 4 EGT sensors on Rotax 912 (Read 140 times)
Nov 12th, 2018 at 12:19am

Teemu Patja   Offline
New Member
EFHF

Posts: 2
*
 
Hi,

The standard sensor package for Rotax 912 contains only two EGT sensors. I would like to have EGT sensors for all four cylinders. The installation manual does not make it clear how to install more than two EGTs for the Rotax. Is this possible with the Dynon clamp sensors and if so, how?

Thanks.
 

Aircraft: EV97, Rotax 912 ULS with EFI
System: EFIS-D100, EMS-D10, AP74
IP Logged
 
Reply #1 - Nov 13th, 2018 at 7:22pm

Dynon Avionics   Offline
Dynon Official
Dynon Technical Support

Posts: 13064
*****
 
Simply buy two more sensors, and either add more EGT wire to your existing D25 connector, or buy a new 4 cylinder EGT/CHT harness and not use two of the CHTS. Then reconfigure your EMS under global settings, and that's about it!
 

Please do not use Private Messaging on form to contact. For private support:
Email: support at dynonavionics dot com
Phone: 425-402-0433 (7am-5pm Pacific weekdays)
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Print